
Archtri provides drafting and permit drawing services for St. Petersburg homeowners, contractors, builders, architects and engineers. We prepare floor plans, elevations, as-built drawings, structural drafting and renderings remotely, formatted for the City of St. Petersburg and Pinellas County building departments. Request a complimentary quote for your St. Petersburg project.
Local conditions
What shapes permit drawings in St. Petersburg
A peninsula city with flood exposure
St. Petersburg is surrounded by water on three sides, and a large share of the city sits in FEMA special flood hazard areas, including neighborhoods near the bayfront, Snell Isle, Shore Acres and Coquina Key. For a new build, drawings usually show the lowest floor against the base flood elevation, flood openings in enclosures below it and the placement of mechanical and electrical equipment. For existing homes, a renovation or addition can trigger the substantial improvement rule, which is based on cost relative to the value of the structure. The city's floodplain staff can tell you how it applies to your parcel.
Wind, coastal exposure and storm recovery
Pinellas County is a densely built peninsula with significant exposure to hurricane winds and storm surge. Drawings for new construction, additions and reroofing often carry wind design notes, opening protection details and connection details selected by the engineer or designer of record. After storm seasons, many owners also need repair and rebuild drawings that show existing conditions accurately so that the scope can be reviewed and permitted. We draft those documents clearly, and we leave jurisdiction-specific wind and product approval decisions to your building department and design professional.
Mid-century homes and a growing urban core
St. Petersburg has a deep stock of mid-century homes, bungalows and block houses, plus a downtown and corridor areas where mixed-use and multifamily projects are being built. That mix means a lot of renovation work, which starts with good as-built drawings, as well as small-scale infill projects that need a clean permit set. Some areas have locally designated historic districts with additional review for exterior changes, so check early whether your address is affected.
Requirements differ by jurisdiction and change over time. Always confirm current code, flood, zoning and submission requirements for your address with the St. Petersburg area building department or Pinellas County before you finalize a design.
Services
Each service below is delivered remotely and formatted to the submission requirements of your building department.
Architectural Drafting in St. Petersburg
We provide our clients with up-to-code and functional drafts that represent the construction you imagined with precision. This draft will help your construction team bring your imaginations to life.
Structural Drafting in St. Petersburg
In order to check the feasibility of your construction work, we offer structural drafting services. With the help of the latest drafting software and skilled drafters, we provide you with detailed design and construction drawings for your project
Photorealistic 3D Renderings in St. Petersburg
If you are looking for 3D designs with meticulous attention to detail, Photorealistic 3D Renderings are your solution. We use cloud data to create 3D models complete with every detail, including utilities and multiple layers
3D Animated Tours in St. Petersburg
Save yourself from the expense of constructing a full model home and experience 3D Animated Tours. You can take a virtual tour of your potential project and get a better sense of what you’ll be getting as an end result.
Lot Surveying in St. Petersburg
Archtri provides lot surveying services for empty lots that would hold your potential commercial or residential building. Our job is to determine whether the land you are planning construction on is stable or not.
Engineering Calculations in St. Petersburg
Our engineers provide you with accurate calculations that back up your construction plan to help you design your home or commercial building. This ensures your construction team has accurate measurements with them when they start the project.
BIM Modeling in St. Petersburg
Contractors, designers, installers, and cost consultants can use the BIM Modeling technology to take a thorough look into the primary elements present in any construction project. This allows them to change any variables as per the demands of the project. All components of the project are integrated using 3D BIM modeling technology, including concept, project controls, budgeting, scheduling, building, and accounting, offering holistic solutions to every project.
As-Built Drawings in St. Petersburg
Accurate existing-condition drawings from your photos, measurements and plans.
Typical projects
Projects we draft in St. Petersburg
- Home additions, bump-outs and second-story additions
- Rebuild and repair drawings after storm damage
- Elevating or raising existing homes for flood compliance
- Accessory dwelling units, garage apartments and guest houses where permitted
- Small commercial tenant improvements and mixed-use infill drawings
Who we serve
We work with St. Petersburg homeowners who want to expand or update an older home, contractors who handle renovation and storm repair work, small builders and developers working infill sites, and architects and engineers who want support with drafting and BIM production. We serve St. Petersburg projects remotely.
How a remote project works
Your project moves online. Send photos, measurements, a survey and any existing plans using our quote form. We confirm scope and timeline, deliver drafts for review, make revisions, and send final PDFs and CAD or BIM files that your contractor or the building department can use.
How it works
Receive project
Send us your sketches, plans or ideas. We confirm scope, timeline and what you need delivered.
Planning
We review feasibility, code requirements and the details that drive cost, so surprises surface early.
Creative design
Drafts and renderings come back for your review, with revision rounds built in.
Ready to build
Final drawings go to your construction team: clear, complete and ready to price.
Questions
Do you prepare permit drawings for homes in St. Petersburg flood zones?
Yes. We draft the elevation, flood opening and equipment information your project needs to show, based on the survey, elevation certificate and flood zone information you provide. The city's floodplain staff can confirm which standards apply to your address.
Can you draft drawings for storm repair or rebuild work?
Yes. We create as-built drawings of the existing structure and draft the repair or rebuild scope so that your contractor can price and permit the work. Requirements after storm damage vary by jurisdiction and by the extent of damage, so confirm them with the building department.
Can you work with a St. Petersburg architect or engineer as a drafting partner?
Yes. Many architects and engineers send us design intent and receive production drawings, BIM models or renderings in return, so their staff can spend time on design and review.
How do I start a St. Petersburg drafting project?
Submit the quote form with your address, project type and any sketches, photos or plans. We reply with a quote and timeline, then begin once scope is agreed.